Descripción
NANO TAPE BUBBLES: This is the nano tape bubble you've been looking for! The new upgraded nano-glue bubble is not easy to break, has stronger elasticity and creatability, and can meet your many DIY ideas.
Fun Toys: This Nano Tape Bubble Kit can help you focus your attention and relieve stress. You can use it to create a super cute bubble that's perfect for playing with kids, boys, girls, friends, classmates, colleagues, and family.
SIMPLE OPERATION: Our nano tape bubbles operation is simple,
1.select the appropriate length of nanotape, 2.put straw, 3.add your favorite filler (glitter, glitter, etc.), 4. seal the edge,5.Remove the protective film 6. heat with a hair dryer for one minute. 7. Then you can just blow bubbles.
DIY NANO TAPE BUBBLE: Due to the nano tape bubble is more durable and has stronger elasticity, so it's much more creative. You can DIY your favorite nano tape craft according to your own pleasure, or even fill the bubble with water or quicksand.
Package list:
1 roll 5x300cm nano tape.
1 box of beads.
3 packs of fillers.
1 sticker.
4 bottle of Glitter Powder.
12 small straw.
1 straw.
Caution!
Please read the precautions before using nano tape bubbles!
The reason why the nano tape bubbles does not blow up?
1.No preheating of the nano tape or too short heating time.
Solution: Please use a hair dryer to heat evenly for more than 1 minute.
2.The nano tape around the straw is not pinched tightly or the edge of the nano tape pocket is not pinched tightly, resulting in air leakage.
Solution: Please pinch the edges of the nano tape pocket tightly before blowing bubbles. Please pinch the nano tape around the straw when blowing the nano tape bubbles.
3.The nano tape are all stuck together, leaving no space between them.
Solution: Please be careful not to let the centre nano tape stick together, to form a pocket-like nano tape.
4.The straw is blocked by the nano tape.
Solution: Please note that the straw is placed 0.3-0.5 inches inside the nano tape and is not blocked by the nano tape.
The reason for air leakage?
1.The edge of the nano tape or the nano tape around the straw is not pinched tightly.
Solution: Please pinch the edges of the nano tape pocket tightly before blowing bubbles. After blowing the nano tape bubble, pinch the nano tape where the straw is placed.
2.The edges of the nano tape are too narrow.
Solution: Leave at least 0.2inch of nano tape edge.
3.The size of the nano tape you cut is too small and the bubble is too big.
Solution: Do not blow a single layer of nano tape bubbles over 5 inches.
4.Insufficient heating time or uneven heating, resulting in partial breakage and air leakage.
Solution: Please use a hair dryer to heat the nano tape evenly for more than 1 minute before blowing